EKWB EK-Quantum Vector FE RTX 3070 GPU Water Block, Digital RGB, Nickel/Plexi

Description

EK-Quantum Vector RTX FE 3070 D-RGB water block is compatible with Founders Edition GeForce RTX 3070 graphics cards. Purpose-designed with a much thicker copper base to clear the tall components on the card and additionally, allows the terminal to be screwed directly onto the copper cold plate. Features a unique plexi terminal that is located in the far end of the GPU.
The Vector water block directly cools the GPU, VRAM, and the VRM. Contacts with the MOSFETs and chokes to maximize cooling and minimize the chances of coil whine. Features optimized flow paths that reduce hydrodynamic instabilities and vortexing inside of them.
The GPU block uses an Open Split-Flow cooling engine design, and is characterized by low hydraulic flow restriction. The jet plate and fin structure geometry have been optimized to provide even flow distribution with minimal losses and optimal performance.
Fin array is populated by 23 microfins with 0.6mm wide microchannels that provide optimal cooling performance.
These Vector GPU water blocks also feature plexi terminals that match the top cover. The watertight sealing is ensured by high-quality EPDM O-rings, while brass standoffs are already pre-installed.
The aesthetic end-piece is housing the addressable D-RGB LED strip. This water block boasts a total of 5 individually addressable RGB LEDs, and it is compatible with popular RGB sync technologies from all major motherboard manufacturers.
Enclosed:
- EK-Quantum Vector RE RTX 3070 D-RGB
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- 2x Nickel plated brass plug G1/4”
- EK-Loop Multi Allen Key (6mm/8mm/9mm)
- Thermal pads and grease
Technical Specification:
- Dimensions: (LxHxW) - 205x98x21mm
- D-RGB cable length: 500mm
- D-RGB LED count: 5
- D-RGB connector standard 3-pin (+5V, Data, Blocked, Ground)